Session 1 Day3

Hi folks,

The agenda for today is to learn the intuition for decision trees and artificial neural networks.

The dataset and scripts for decision trees:

https://drive.google.com/drive/folders/1n386wJlSC0gUX2Ty6PsfPLEIgtvtcJt9?usp=sharing


The dataset and scripts for Neural nets:

https://drive.google.com/open?id=1gDPDemTfG26iMqiweRQg1l6J6yPX3Ufk



Comments

Post a Comment

Popular posts from this blog

Day 2 Session 1: Introduction to Zodiac FX switch

Image
Hello All, The Zodiac FX switch something like this: The first three ports from the left can be used to connect to any host or any other Zodiac FX switch while the fourth port must be connected only to the controller. Here, the controller refers to the system where you are running any Ryu controller code (or any other controller like ODL, Pox or so on). We need the putty software to set up this piece of hardware before we could use it. TO set it up, we can follow the following command once we have opened a Serial Input SSH terminal from Putty. To know more about Zodiac FX switch, how to install and update its firmware and know its various components, refer to this link: https://forums.northboundnetworks.com/index.php?topic=52.0 https://forums.northboundnetworks.com/downloads/zodiac_fx/guides/ZodiacFX_UserGuide_0517.pdf The following commands are to be typed in a Putty session connected to the Zodiac FX switch- config show config set name ZodiacFX1 set ip-address 192...
Read more

Day 3 Session 2: Building an SDN network

In this session, we shall initially be building a basic SDN network with 1 Controller, 1 Zodiac FX switch and 2 Hosts. Later, we shall look into how OpenFlow protocol installs flows in the Zodiac FX switch using 2 software packages: putty Wireshark After this, we shall create DDoS attacks and see how the controller reacts. We shall also see how to detect DDoS attacks from the controller. Here is a recap of Day 2, which is necessary to understand tomorrow's session: Step 1: Connect a USB cable to power the Zodiac FX switch and the other end to the laptop. Note that the Zodiac FX switch can be powered from any device and not just the controller. Step 2: Open a terminal and execute the command dmesg | grep tty Note the port of the system the USB ACM device is connected to. It's usually ttyACM0 or ttyACM1. Step 3: Open putty terminal by executing this command sudo putty Go to the Serial Connection Type and give /dev/ttyACM0 or /dev/ttyACM1 ...
Read more